Hole- and Seam Sealer 12g (ca. 1/2 oz.) + Hol Finder - Kit
The HOLE FINDER included in this SET is a clever tool for finding and locating small holes, for example in insulating mats, air mattresses, rubber dinghies, pools, etc.
The HOLE- & SEAM SEALER 12g from fishingglue.de is the "solution" for quickly sealing seams and small holes up to max. 3mm* in items made of soft PVC, artificial leather and PU (polyurethane) as well as for fabric and fabric surfaces made of vinyl, polyester and nylon. For example for films, tarpaulins, umbrellas, tents, shoes, rainwear, etc. Our HOLE & SEAM SEALER is very economical, milky-transparent after drying, UV-resistant, does not become brittle and adheres well. Thanks to the ergonomic dosing tip, you can apply the HOLE & SEAM SEALER well and dose it easily.
* Please use our PVC and PU repair kits for holes larger than 3 mm in diameter.
Operating Instruction Hole- and Same -Sealer
Clean the area to be repaired or the seam to be sealed from dirt and dry (also free of grease and silicone!). Then apply the HOLE & SEAM SEALER generously to the damaged areas or the seam and leave to dry for at least 30 minutes. Repeat the order if necessary.
The drying time for highly stressed parts such as sleeping pads, air mattresses, etc. is at least 3 hours!
If you are not sure whether the defective article/the defective material can be repaired with the HOLE & SEAM SEALER, you should test the application first on a non-visible area!
Avoid direct sunlight and draughts for every repair/application! Temperatures below 5°C can negatively affect the repair result.
Operating Instruction for use Hole Finder
For application, the damaged part (ISO mat, air mattress, etc.) must still contain air. In case of complete loss of air again fill some air in the damaged part. With the grid side down, guide the hole finder over the surface to be tested until the moving beads indicate the leak / hole. Mark this location, e.g. with a pen. Now remove the air from the part to be repaired or let the air escape so long that no more air escapes from the damaged area. Now you can repair or seal the damaged area with the Hole- and Same -Sealer according to the instructions below.
Specification Hole- and Seam Sealer
- Special solution for sealing seams and small holes in articles made of soft PVC, imitation leather and PU (polyurethane) as well as for fabrics and fabric surfaces made of vinyl, polyester and nylon.
- Milky-transparent after drying, UV-resistant and flexible
- Dimensions approx. 120 x 40 x 22mm (L x W x H)
- Total item weight: approx. 35 g
Specification Hole Finder
- Aid for the search or for detecting small holes in air-filled parts
- Dimensions approx.: Ø 40 mm
- Total weight of the item: approx. 20 g.
Form of delivery Hole- and Seam Sealer
in a sturdy resealable plastic box:
- 1 tube HOLE- & SEAM SEALER 12 g
- Instructions for use on the bottom of the pack
Form of delivery Hole Finder
- 1 piece of hole finder / hole sniffer with a diameter of approx. 40 mm packed in a PE bag and
- one 4-page instructions for using the Hole Finder from fishingglue.de
Storage / Shelf Life
The warehousing and application- temperature should ideally be 10 - 25°C. Storage at temperatures below 5°C the Hole- and Seam Sealer may crystallize and is characterized possibly temporarily unusable. When heated to room temperature crystallized products they are again fully usable.
Unopened the Hole- and Seam Sealer is several years, if stored under recommended storage temperature.